Instruction manual

–

Set the lever on the step motor to marking.

–

Set the gear to “0”.

In order to do so, tur n the positioning frame 14 so that the tongues

come parallel to each other.

–

Tighten the screw 13 on the block 12.

–

Align the feed dog in longitudinal direction in the center of the

throat plate cutout.

–

Tighten screw 5 (see picture on page 10).

–

Fit in the spring 1 (see picture on page 10) on the positioning

frame and the fastening bracket.

ATTENTION: Danger of breakage!

The shaft 11 must not reach so far into the positioning frame 14 that

the tongues are hindered in their movements.

11 12 13