Instruction manual

2.3.2 Position of the feed dog in the throat plate cutout

Caution: Risk of injury!

Tur n off the main switch.

Check and set the position of the feed dog and stitch regulator gear

only when the machine is switched off.

–

Loosen the threaded pins on the adjustment rings 8 a nd 9.

–

Loosen screw 5.

–

Align the feed dog in the center of the throat plate cutout.

–

Arrest the shaft 7 with the adjustment rings 8 and 9 and tighten

the screws.

–

Loosen threaded pin 10 and screw 2.

–

Loosen the threaded pins on the thrust eccentric 4.

–

Align the positioning frame 14 laterally so that it comes to sit in the

center between the cutouts on the shaft 7.

–

Arrest the positioning frame 14 axially with the bearing bolt 6

(fixed with screw 10) and the adjustment ring 2.

–

Tighten the threaded pins on the thrust eccentric 4.

Note:

The shaft 11 is fixed on surface in the positioning frame 14

at position 3 with two screws in series.

7654314

10 11