Instruction manual

4.12 Adapting barcode definitions

In order to carry out changes in the barcode labelling system the

operator must be authorized to security level 2.

–

Call up “Check”.

–

Call up “Setup”.

–

Call up “Barcodes”.

–

Select the corresponding type in the field “Primary barcode type”.

This barcode is read via hand scanner.

–

Select the corresponding type in the field “Thread barcode type”.

This selection applies to both needle and hook thread.

–

Select the corresponding type in the field “Endlabel barcode

type”.

–

In the following fields masks can be defined to transmit

system-relevant information (entry: “1”) and ignore unimportant

information (entry: “0"): “Prim. barcode identifier A” (barcode for

material and colour), “Prim. barcode identifier B” (barcode for the

top and bottom piece), “Prim. barcode identifier C” (barcode for

theseampattern)and“Prim.barcodemaskL/R”(barcodeforthe

left and right piece).