Operating instructions

6.6 Error codes
EC10000 fault clearance by supervisor
EC20000 check thread tensioner (not in use at present)
EC21000 forced thread-cutting in a rupture seam
EC21500 Received wrong error message from Efka motor
EC21600 Received hook thread message from Efka motor
EC22000 forced bar-tacks in a rupture seam
EC22500 wrong bar-tacking in the seam
EC22600 wrong stitch count, motor and PC
EC23000 thread break in a rupture seam
EC23500 thread tension too low in a rupture seam
EC23600 thread tension too high in a rupture seam
EC25000 thread break in a free seam
EC25500 thread tension too low in a free seam
EC25600 thread tension too high in a free seam
EC26000 unknown barcode label (supplementary barcode)
not read
EC27000 hardware fault, DA82 sewing motor not responding
properly
EC27500 hardware fault, ELTEX thread-tension measuring device
not responding properly
EC28000 below permitted stitch range
EC28000 above permitted stitch range
EC31000 end-label barcode misread by supervisor using
manual scanner
EC31500 wrong end label sewn into piece
EC32000 a bobbin containing a prohibited thread was inserted
during sewing
EC33000 barcode printer not ready
ECxxxxxACK error “xxxxx” confirmed by supervisor
ECxxxxxCNT Supervisor has released the piece for further processing
despite error ‘xxxxx’
50