Operating instructions

5.6.3.4 Entry of the Gradation
The gradation is immediately active after the pressing of the ‘4’ key of
the numeric keypad and is highlighted with a black shadow bar. The
value shows by how many mm the partial seam length of the program
step changes with each size change. Enter gradation in mm, as
necessary. The desired gradation can be entered as one to two digits
via the numeric keypad. The value is taken on through the pressing of
the OK key. Sewing is not possible during entry of the gradation.
Gradation:
Direct selection of the gradation parameter
Entry :
to Numeric entry
Confirmation of the numeric entry
Retain old numeric value unchanged
5.6.3.5 Turning On the Special Functions
A supplementary window showing the active or inactive special
functions as symbols is opened with the 5 key of the numeric keypad.
The special functions are step-dependent, that is, e.g. in the current
step 3 the supplementary thread tension can be turned on while in the
steps 1, 2 and 4 the supplementary thread tension is tur ned off.
The selection of the two currently available s pecial functions
Thread tension and Supplementary thread tension
occurs via the Cursor Left and Cursor Right keys.
The activation or deactivation of individual functions is conducted by
pressing the OK key. The supplementary window is exited again via
the F1 soft key.
92