Operating instructions

5.6.3.3 Determination of the Current Partial Seam Length in mm
The partial seam run length can be programmed in mm in two different
manners.
·
Variant 1
The partial seam run length is immediately active after the
pressing of the ‘3’ key of the numeric keypad and is highlighted
with a black shadow bar.
The seam run length (mm) can be directly programmed w ithout
having to sew through entry of a three-digit numeric value via the
numeric keypad. The set value is saved by pressing the OK key.
Partial seam run length:
Direct selection of the partial seam run length parameter
Entry : 1 ... 255 [mm]
to Numeric entry
Confirmation of the numeric entry
Retain old numeric value unchanged
·
Variant 2
When sewing, the desired partial seam run length in mm is
determined.
During sewing, the partial seam run is automatically counted in
mm and continuously displayed in the screen. When the desired
partial seam run is finished, it is saved through a simple advance
to the next program step (see Chapter 5.6.3.1)
Foot pedal Automatic seam run measurement in mm
Value range : 1 ... 255 [mm]
Value storage through step advance
ATTENTION !!!
If the thread trimmer is triggered at the end of a partial seam run, the
parameter value returns to zero.
91
4