Operating instructions
5.6.3.1 Selection of the Current Step
One advances to the next program step with the 2 key of the numeric
keypad or with the knee switch. The current step number is shown
next to the symbol and in the display of the key panel, all other
step-dependent parameter changes are updated in the screen.
During sewing, the partial seam run is automatically counted in mm
and continuously shown in the screen. When the desired partial seam
run is finished, then the partial seam run, bunching value, gradation
and special functions parameters are automatically saved with the
advance to the next program step.
Current step :
Direct selection of the step advance function
Display: Current step
max. 26 steps in t he sewing program.
max. 13 in the current piece (left or right)
Note:
If a starting piece consists of more than 13 piece steps, mirroring is no
longer possible!
5.6.3.2 Changing of the Bunching Value / Fullness
A change of the bunching value / fullness can always be conducted
immediately and directly via the key panel (Illus. 2.4).
The current value is shown next to the symbol and in the display in the
key panel.
Bunching value / fullness:
to Direct selection of the fullness
Entry:0, 0.5, 1, 1.5 ... , 13.5, 14, 14.5, 15
90