Operating instructions

5.6.2.1 Changing the Size Setting
The size selection is immediately active a fter the pressing of the ‘1’
key of the numeric keypad and is highlighted with a black shadow bar.
The desired size can be entered as one to three digits via the numeric
keypad. The value is accepted through the pressing of the OK key.
After the deletion of a sewing program the base size is always still set.
Size
Direct selection of the size parameter
Entry: seeDOB/HAKASizeTables
to Numeric entry
Confirmation of the numeric entry
Retain old numeric value unchanged
NOTE:
If a size is entered which is not a part of the size table of the current
size group, the set value is corrected to the following procedure :
·
The value is smaller than the valid value range of the size table
Þ Correction to the min. size value.
·
The value is within the value range but not a valid value of the size
table
Þ Correction to base size
·
The value is larger than the valid value range of the size table
Þ Correction to the max. size value
85
4