Operating instructions

5.6.1 Presetting - “TEACH”
All important base parameters, the sewing graphic and the program
number are shown in the “TEACH” selection screen (Illus.5.6.1-1). In
the heading of the screen, the machine class, the name of the current
window and the number of the displayed sewing graphic are shown.
Next to the display of the program number the program name (here:
MODELL 47/11) is, if present, shown.
The selection of the base parameters,
Sewing graphic
Application area
Size and
Starting piece,
is not possible at this time, only the settings are shown.
Illus. 5.6.1-1: Selection screen for the “TEACH” presetting
Before the generation of a new sewing program, the ‘F2’ soft key
should always be pressed first in order to delete an old program. A
deleted sewing program is reinitialized with the DOB/HAKA base
settings (Chapter 5.4) and the country-specific size system and edited
with the base size.
After the “TEACH” selection screen is called up the program number
is highlighted with a shadow bar (Illus. 5.6.1-1). It is active and can, if
desired, be changed directly with a two-digit entry via the numeric
keypad. The new program number is saved by pressing the OK key
and the data for the new sewing program are updated in the screen.
82