Operating instructions

5.6 TEACH Programming Mode

A sewing program is generated for the base size with the Teach-In

procedure and automatically mirrored and graduated, if desired. The

controls measure the partial runs during sewing of the individual steps

and automatically enter them in the program.

The selection of the “TEACH” programming mode occurs by pressing

the ‘F4’ soft key in the “AUTO” main screen.

The “TEACH” programming mode consists of a total of three setting

levels and is divided as follows:

Level 1:

Presetting - “TEACH”

Opportunity of selection of the current sewing program number

(01-15)

Opportunity of deletion of the current sewing program.

Level 2:

Preselection - “TEACH-SELECT”

Opportunity of changing the base parameters size, application

area

DOB / HAKA, sewing graphic and current piece LEFT / RIGHT.

Opportunity of entering a sewing program name.

Opportunity of selecting between the two programming modes

“TEACH-IN” (while sewing) and “MODEL” (not sewing).

Level 3:

Entry mode - “TEACH-IN” or “MODEL”

Entry of the program parameters - current step, fullness /

bunching value, partial seam length, gradation, special functions.

Opportunity for mirroring the current application piece.

Opportunity for copying to all sizes of the current size table.