Operating instructions

5.5.5 Selection of the Speed in the Bartack

The speed in the bartack can only be selected and changed when a

beginning or end bartack (single / double) was previously selected.

If the “Without Beginning Bartack” and

“Without End Bartack” settings were selected, then a

parameter call-up via the ‘Cursor Left’ and ‘Cursor Right’ or ‘Cursor

Up’ and ‘Cursor Down’ soft keys is not possible. The corresponding

symbol is skipped.

Bartack speed:

Entry : 500, 600, 700, ..., 1800, 1900, 2000 [rpm]

/ Selection of the numeric value

Confirmation of the numeric entry

5.5.6 Seam Length Measurement through Light Barrier

Sewing length measurement :

Light barrier (Currently without function)