Operating instructions

5.1.8 Display of the Current Partial Seam Length in mm

The current seam length (mm) is continuously shown in the screen and

immediately updated after a step change. The partial seam length can

only be changed via the TEACH programming mode (Chapter 5.6).

Partial seam length:

Display: Seam length of the piece segment in mm

(max. 255 mm)

5.1.9 Display of the Special Functions

A supplementary window showing the active or inactive special

functions as symbols is opened with the 5 key of the numeric keypad.

The special functions are step-dependent, that is, e.g. in the current

step 3 the supplementary thread tension can be turned on while in the

steps 1, 2 and 4 the supplementary thread tension is tur ned off. An

activation or deactivation of individual functions, as is possible in the

TEACH-IN programming mode, can not be conducted. The

supplementary window is exited again via the F1 soft key.

Special functions:

Direct selection of the “SF” supplementary window

Status display: Thread tension ON/OFF

Supplementary thread tension ON/OFF

Close the “SF” supplementary window