Operating instructions

5.1.6 Selecting the Current Step
One advances to the next step w ith the 2 key of the numeric keypad
or with the knee switch. The current step number is shown next to the
symbol and in the display of the key panel, all other step-dependent
parameter changes are updated in the screen. The progress of the
seam run is marked accordingly in the graphic (Illus. 5.1-1).
During sewing, there is an automatic advance to the next piece step
when the partial seam run is finished. In the last piece section the
seam run measurement is switched off. A change to the right or left
piece occurs after the sewing of the prescribed run and the thread
trimming procedure.
Current step :
Direct selection of the step advance function
Display: Current step
max. 26 steps in t he sewing program.
max. 13 in the current piece (left
or right)
Note:
If a beginning piece consists of more than 13 piece steps, then
mirroring is no longer possible!
5.1.7 Change of the Bunching Value / Fullness
A change of the bunching value / fullness can always be made
immediately and directly via the key panel (Illus. 2.4).
The current value is shown next to the symbol and in the display in the
key panel.
Bunching value / fullness:
to Direct selection of the fullness
Entry:0, 0.5, 1, 1.5 ... , 13.5, 14, 14.5, 15
The changed bunching value is only valid for the current piece
segment. When the piece segment is called up again the bunching
value stored in the sewing program is used. A permanent change of
the bunching value is only possible via the TEACH-IN function.
52