Operating instructions

5.1.2 Selection of the Size
The size selection is immediately active a fter pressing the ‘1’ key of
the numeric keypad and is highlighted with a black shadow bar. The
desired size is entered one to three-digit v ia the numeric keypad. The
value is saved by pressing the OK key. By selection of a base size, t he
size range is also shown and marked accordingly (Illus. 5.1-1). Sewing
is not possible during the size selection.
Size
Direct selection of the parameter-size
Entry: seeSizeTablesDOB/HAKA
to Numeric entry for desired size
Confirmation of the numeric entry
Retain the old numeric value
unchanged
Marking of the base size through
display of the size range
(MIN-BAS-MAX)
NOTE:
If a size is entered which is not a part of the size table of the current
size group, the set value is corrected with the following procedure :
·
The value is smaller than the valid value range of the size table
è Correction t o the min. size value.
·
The value is within the value range but not a valid value of the size table
è Correction to base size
·
The value is larger than the valid value range of the size table
è Correction to the max. size value
5.1.3 Display of the Application Area DOB / HAKA
The alter nation between the DOB / HAKA application areas cannot be
conducted in automatic operation, the preselected area (in the TEACH
function screen) is shown by the highlighted figure in the display
symbol (Illus.5.1-1).
Application area:
Application area HAKA - Men’s and Boy’s Wear
Application area DOB - Women’s Wear
50