Instruction manual

26
9. Sewing with machine equipped with positioning motor
9.1 Machine automatic functions
The machine has functions stated below which are automatically
carried out
during the seam sewing dependent on:
–
pre-selection
–
pedal position (according to the machine operator s selection)
–
work phase of seam sewing
Automatic function
Pre-selection
Needle positioning
•
needle down at machine seam-stop
•
needle up at machine seam-stop
Note: After the seam finishing* the machine always stops with the needle up.
Bars
•
standard
•
ornamental**
Initial bar
•
single
•
double
•
standard bar stitch number forwards
•
ornamental bar stitch number forwards
•
standard bar stitch number backwards
•
ornamental bar stitch number backwards
End bar
•
single
• double
•
standard bar stitch number backwards
•
ornamental bar stitch number backwards
•
standard bar stitch number forwards
•
ornamental bar stitch number forwards
Thread trimming
•
on
•
off
Automatic foot lifting
•
foot lowered at seam-stop
•
foot lifted at seam-stop
* The seam is finished after the pedal transition to position -2 (if the thread trimming is pre-selected, then after
trimming).
** At the bar sewing, the ornamental bar is characterized by the needle sticking in the same points as in the
previous seam.On the sewing direction change the machine will stop for a moment.