Instruction manual

7.10 Setting of zig-zag stitch width (throw) and position

Attention!

At setting the zig-zag stitch width (throw) and position the needle must

not be inside the sewn material. There is a threat of the needle

breaking!

Setting of zig-zag stitch width

–

Press the lever (1) in the arrow direction (A) until it strikes the lever

(2)

- the lever arrest is released (2). Grip both levers at the same time

and set the zig-zag stitch width by turning the lever (2) against the

selected number indicating the stitch width.

–

Arrest the lever (2) position by turning the lever (1) against the

arrow direction (A).

Setting of zig-zag stitch position

–

Press the lever (1) in the arrow direction (A) until it strikes the lever

(2)- the lever arrest is released (3). Make sure that the lever setting

does not change at the arrest switching off (2).

–

Press the lever (3) and turn it at the same time up to the stop

(inside the machine) against the respective symbol indicating the

zig-zag stitch position. Only the middle position of the lever is

arrested with a lock.

–

After the lever (3) setting, carry out arresting with the lever (1).

–

In picture (C) there are examples of setting the zig-zag stitch width

and position from which it is visible that the zig-zag stitch width

does not change at the position change.