Operating instructions

3.4 Connect the control box to the main switch

ATTENTION !

Any kind of work on the electric equipment of the automatic bartacker

must be carried out only by electricians or trained personnel.

The mains plug has to be pulled out!

–

Take off the switching k nob 1.

For this purpose loosen the screw 2 in the knob.

–

Remove the cover 3 from the main switch.

For this purpose unlock the locking bar in drill-hole 4 with a

screwdriver.

–

Run the cable from the control box into the cable duct.

–

Insertthecableinthemainswitch.

–

Connect the cable cores of the control box to the

screws ”T1” and “T2”.

–

Connect the protective conductor of the control box in

themainswitch.

–

Put the cover on the line switch again.

–

Put on the switching knob 1 and screw it tight.

–

Put on the cover of the cable duct.

21 43