Operating instructions

4. Pneumatic Connection

For the operation of the clamp lifting, thread tension opening, needle

cooling, etc. the unit must be supplied with water-free compressed air.

ATTENTION !

For a flawless functioning of the pneumatic control processes the

compressed air supply must be laid out as follows:

Even at the instant of greatest air consumption the minimum operating

pressure may not fall below 5bar.

Connecting the compressed air maintenance unit

–

Connect the connection hose 3 for the maintenance unit to the

compressed air supply with the enclosed c oupling.

Setting the operating pressure

–

The operating pressure is 6bar.

It can be seen on the pressure gauge 2.

–

For setting the operating pressure pull knob 1 up and turn.

Turning clockwise = Increase pressure

Turning counterclockwise = Decrease pressure