Operating instructions

3. Bobbin winder

Reeling on the spool thread

–

Place yarn reel on reel stand.

–

Thread the thread through the holes 1 in the reel stand.

–

Pass the thread through the tension discs of tensioner 2.

–

Pass the thread through the tension discs of tensioner 3 of the reel.

–

Pass the thread through the slot in guide 4.

–

Pass the thread through the hole 7 in the empty reel.

–

Place the empty r eel on the bobbin shaft 8.

The pin 10 of the bobbin shaft must fit into the hole 7.

–

Pass the thread through the s tar 10 and clamp it in the tensioner 11.

–

Use the thread clipper 6 to c ut off the end of the thread.

–

Raise the thread layer 5.

The bobbin winder is switched on and the winding process begins.

–

As soon as the reel is full the thread layer 5 springs back into

position and the winding process is terminated.

65 432

7891011