Operating instructions

7.2 Keys on the Control Panel
Key Function Settings
P
Accessing or exiting the programming mode
E
Confirming a change in a parameter value
+
Increasing the shown parameter value
-
Decreasing the shown parameter value
1
Stitch counting ON / OFF
2
Programming / Working through the seam runs
3
Function key (programmable)
4
Base position of the needle UP / DOWN
5
Automat. foot lifting during stop in the seam ON / OFF
6
Automat. foot lifting after thread trimming ON / OFF
7
Beginning bartack SINGLE / DOUBLE / OFF
8
End bartack SINGLE / DOUBLE / OFF
9
Thread trimmer ON / OFF
Thread wiper ON / OFF
0
Light barrier function * ON / OFF
* = Key function is not assigned in this machine class.
24