Instruction manual

PAGE - 11
Key
Parameters Function Range Pre.setting Description
HVP -20 Parameters List for DA-281 (MAC. 73)--version 1.0 N
Parameters
Code
INA input logic signal invert
ON：The input logic of each Input signal PSU is reversed.
OFF：The input logic of each Input signal PSU is normal.
INB input logic signal invert
ON：The input logic of each Input signal PSD is reversed.
OFF：The input logic of each Input signal PSD is normal.
INC input logic signal invert
ON：The input logic of each Input INC signal is reversed.
OFF：The input logic of each Input INC signal is normal.
BL controller interface control function selection.
ON：Enable for Pegasus BL controller function . NOTE: Valid only when 【156. OD】=KS4.
OFF：Disable.
For the hemming guide device of USA Bottoms Associates Inc.
OFF：Normal sewing mode.
1：For manual mode hemming guide device.
2：For auto mode hemming guide device.
206 CK1 CK output ON delay angle 0 - 250 degrees 0 CK output on delay angle setting. Valid only when 【157. O1】or 【158. O3】or 【199. O2】 = CK .
207 CK2 CK output OFF angle 0 - 250 degrees 10 CK output off angle setting. Valid only when 【157. O1】or 【158. O3】or 【199. O2】 = CK .
P
O
W
E
R
..
O
N
205 Mode selection for hemming guide device
INC logic signal invert
OFF
ON/OFF
OFF202 IBV
201 IAV
INB = PSD logic signal invert
BL controller interface control
BAF
203 ICV
204 BL
OFFINA = PSU logical signal invert
OFF
OFF
OFF,1,2
ON/OFF
ON/OFF
ON/OFF
＋