Instruction manual

-5-

WARNING:

To avoid possible personal injury due to abrupt start of the machine, turn off the power to the machine

and check to be sure that the motor has totally stopped rotating in prior.

1) Turning the oil amount adjustment screw attached

on the hook driving shaft front bushing in the "+"

direction (in direction ) will increase the amount

of oil (oil spots) in the hook, or in the irection

(in direction ) will decrease it.

2) After the amount of oil in the hook has been properly

adjusted with the oil amount adjustment screw,

make the sewing machine run idle for approximately

30 seconds to check the amount of oil in the hook.

"-" d

· Adjusting the amount of oil ( oil spots ) in the hook

8. ATTACHING THE NEEDLE

9. SETTING THE BOBBIN INTO THE BOBBIN CASE

10. ADJUSTING THE STITCH LENGTH

1) Pass the thread through thread slit and pull the

thread in direction .

By so doing, the thread will pass under the tension

spring and come out rom notch .

2) Check that the bobbin rotates in the out direction

from the arrow when thread is pulled.