Operating instructions

Short Seam Automat 2110-5 / 2111-5 Workinging Instructions
- D 72 -
Beisler Automated Sewing Equipment
D.3
Programming
D.3.3 Service menu level 1
Terminal assignment for lock stitch (1-4): S23 *Top thread monitor
Terminal assignment for chain stitch (5-8): S24 *Bottom thread monitor
Terminal assignment *plug X2:
yellow 1
green 2
white 3
brown 4
Valve Output
number
Cylinder
number
Signal
output
Valve
type
Y01 01 Open / close clamp 01 X07 Pin02 5/2 way
Y02 02 Move clamp in / out sideways 02 X07 Pin03 5/2 way
Y03 03 Swing folder left / right 03 X11 Pin20 5/2 way
Y04 04 Rotate folder 04 X11 Pin21 5/2 way
Y05 05 Open / close folder clamp 05 X11 Pin22 5/2 way
Y06 06 Open / close sliding table 06 X11 Pin26 5/2 way
Y07 07 Lift table open 07 X11 Pin27 5/3 way
Y08 08 Raise / lower stacker stamp 08 X11 Pin23 5/2 way
Y09 09 Open / close pocket bag clamp 09 X07 Pin10 5/2 way
Y10 10 Thread clamp forward / rearward 10 X07 Pin06 5/2 way
Y11 10 Blow thread in, synchronous with Y10 X07 Pin06 3/2 way
Y17 17 Open / close label feed clamp 17 X07 Pin08 5/2 way
Y18 18 Lower / raise label feed 18 X07 Pin09 5/2 way
Y31 31 Thread cutter 31 X07 Pin05 3/2 way
Y33 08 Blowing at stacker transport,
synchronous with Y 08
X11 Pin23 3/2 way
Y34 34 Folder up 34 X11 Pin18 3/2 way
Y35 35 Folder down 35 X11 Pin19 3/2 way
Y36 36 Thread tension blower 36 X07 Pin04 3/2 way
Y37 37 Stacker transport rear 37 X11 Pin24 3/2 way
Y38 38 Stacker transport front 38 X11 Pin25 3/2 way
Y45 01 Blowing at clamp, synchronous with Y01 X07 Pin02 3/2 way
Y48 48 Lift table sinks 48 X11 Pin28 5/3 way
Switch Input
number
Switch type Signal
input
S01 01 Start switch Footswitch Make X09 Pin01
S04 04 Clamp reference point Initiator NPN Break X09 Pin04
S07 07 Folder at right stop Initiator NPN Make X09 Pin07
S08 08 Folder at left stop Initiator NPN Make X09 Pin08
S10 10 Stacker transport stop position Initiator NPN Make X09 Pin10
S17 17 Label feed on / off Footswitch Make X13 Pin17
S21 21 Photocell beginning / end of seam Photocell NPN X13 Pin21
S22 22 Photocell stack height Photocell NPN X13 Pin22
S23 23 *Top thread monitor Probe *Plug X2
S24 24 *Bottom thread monitor (chain stitch) Probe *Plug X2
S25 25 Spool rest thread monitor (lock stitch) Photocell NPN X13 Pin25
Inputs
Outputs