Operating instructions

Create seam pattern

In this menu the X- and Y-coordinates are entered for every individual

stitch.

add stitch

parameter/end

Note

In order to enter stitch operations (f.e. intermediate cutting), first

complete the seam pattern (entering of the coordinates) and then

insert the stitch operation through editing in the menu “Changing seam

pattern”.

X1:

Input of the X-coordinate for stitch 1

Input: -20.0 … +20.0

Y1:

Input of the Y-coordinate for stitch 1

Input: -10.0 ...+10.0

Note:

The value X1 can be altered according to chapter 8.3.1.

Select the menu item Y1 with key “ò” after confirmation of the value

forX1withkey“OK”.

The values for Y1, X2, Y2, X3 and Y3 can be altered as described for

the value X1.

Select menu item “Add stitch”withkey“ò” after confirmation of the

input of Y3 with key “OK”.

After selection of this line with key “OK” the next coordinates Xn+1 and

Yn+1 (here: X4 and Y4) are given in the two upper menu lines. The

selection bar changes to the line Xn+1 (here: X4) automatically. The

values Xn+1 and Yn+1 can be altered as described above when

required. This procedure can be repeated until the stitch coordinates

are completely entered. When the input of coordinates is finished, the

line “Exit” has to be selected in the submenu “Parameter/End”. Then

the menu “Free seam patterns” appears again.

Add stitch

Function for adding a stitch.

The coordinates for the first three stitches (here: X1/Y1, X2/Y2 and

X3/Y3) are shifted upwards and the display shows Xn+1/Yn+1 (here:

X4/Y4).