Operating instructions

Auto-Input test
With this test function the function of the input elements is checked.
ATTENTION !
The input elements have been carefully adjusted in the factory.
Adjusting and correcting must only be done by trained service staff.
Caution: Danger of injury !
Do not reach into the working area of the clamping foot when starting
and ending the input elements.
–
Start test function with the key “OK”.
–
Actuate desired input element.
The switch status and the number of the actuated input element
are indicated.
auto input tst
–
Actuate the function key “ESC” in order to leave the test function.
The menu Multitest is indicated.
Input element Function
S 1 Pedal 1
S 2 Pedal 2
S 3 Pedal 3
S 4 Pedal 4
S 5 Hand switch 1, if the option is activated
S 6 Hand switch 2, if the option is activated
S 7 Depending on the option activated and the input configuration
S 8 Check clamping foot
Ref. N Referencing switch for the sewing motor
Ref. X Y-reference switch
Ref. Y X-reference switch
The recent configuration of the inputs is indicated in the submenu
“Input configuration” of the menu Equipment.
1
55