Operating instructions

Lock seam pattern
In this submenu individual seam patterns can be released or locked
for selection in the sewing mode.
lock all
unlock all
on
on
on
on
on
on
Note
If a clamp with non-rectangular shape (Number 9 to 13) is selected in
the menu “Machine configuration/ Equipment”, a manual locking is not
possible. The menu item cannot be selected because for these
clamping feet only specified seam patterns are defined (see table of
seam patterns chapter 11).
In general the following restrictions apply:
1. Seam pattern operation
·
The seam pattern currently selected in the sewing mode cannot be
locked.
·
In the sewing mode, locked seam patterns cannot be chosen from
the selection list.
Locked seam patterns are marked with “#”.
2. Seam pattern sequence operation
·
A locked seam pattern can be selected in a sequence. However,
when starting the sewing process (lowering of the clamping foot)
an error message appears. The sewing process cannot be started.
·
The last seam pattern selected in the seam pattern operation
cannot be locked.
Lock all
All seam patterns with the restrictions specified above will be locked.
The status of the displayed seam pattern number switches to “OFF”.
Unlock all
All seam patterns will be released.
The status of the displayed seam pattern number switches to “ON”.
Lock/unlock individual seam pattern
Input: ON / OFF
1
47