Operating instructions

The menu items t5 - t9 will appear, only if the option “thread burner” is
activated under menu machine/equipment/configuration.
Time to preheat the burner
Time allocated for the preheating of the burner points before the seam
end.
Input: 0 ... 5000ms
Preset value: 2000ms
Select only the necessary time needed for the burning of the threads,
otherwise the burner points can be damaged.
Delay before thread puller
Delay after advancing the lower thread burner puller, after the thread
puller (thread wiper) is activated.
Input: 0 ... 500ms
Preset value: 100ms
Delay before upper burner
Delay after the activation of the thread puller (thread wiper), after the
upper thread burner is advanced.
Input: 0 ... 500ms
Preset value: 100ms
Time thread puller (thread wiper) on
The duration of the thread puller (thread wiper) is switched on.
Input: 0 ... 3000ms
Preset value: 2000ms
Delay heating burner off
Delay after the thread puller (thread wiper) is turned off, after the
heater of the burner is turned off.
Input: 0 ... 500ms
Preset value: 100ms
44