Operating instructions

Testing mode with the control panel BF3
–
Actuate the keys “OK” + “F”: clamp 1 will be lowered
–
Actuate the “OK” key: clamp 2 will be lowered
–
Actuate the “OK” key again: the testing process will be started
–
Actuate the “ESC” key: the clamp closed last will be lifted again
Sewing process with the hand switch (optional)
–
Actuate key 1: clamp 1 will be lowered
–
Actuate key 2: clamp 2 will be lowered
–
Actuate key 2 again: the sewing process will be started
–
Actuate key 1: the clamp closed last will be lifted again
–
Actuate key 1 and keep it pressed (1,5 sec.): clamp 1 and clamp 2
will be lifted
Laser lights
Activating the 3 optional laser lights.
Input: ON/OFF
Thread burner
Activating the optional thread burner device. If the option thread burner
is switched on, the menu items t5 - t9 are listed under machine/ timings
allowing the setting of various times.
Input: ON/OFF
Optical signalling
Via this submenu an indication of error and event messages and of the
message “hook thread is zero” can be configurated and activated via
two 24V-outputs.
Optical signalling
Activating of the indication. Beforehand outputs 1 and 2
must be configurated, otherwise this menu item cannot be
selected.
Input: ON/OFF
Output 1
Selection of the output for error and event messages.
Input: 1 ...8 (if 24V-outputs are vacant)
Output 2
Selection of the output for the message “hook thread is
zero”
Input: 1 ...8 (if 24V-outputs are vacant)
Assignment of the inputs
This menu item gives on overall view of the assignment of the inputs
with (optional) units.
Assignment of the 24V-outputs
This menu item gives an overall view of the assignment of the
24V-outputs with optional units.
42