Instruction manual

3.2 Completing the table top with the control and fastening it to the stand

–

Insertthemachineheadsupport15intotheboreofthetabletop.

–

Insert the rubber supports 14 for the machine head into the

recesses of the table top 12.

–

Insert rubber corners 13.

–

Screw drawer 11 with its holders under neath the table top on the

left.

–

Screw cable duct 10 under neath the table top at the back.

–

Punch-mark the positions of the screw connections of the oil drip

pan 2 and fasten it with wood screws under the cutout of the table

top.

–

Fasten the table top 12 with wood screws (B8 x 35) on top of the

stand.

The alignment on the stand is specified by the measurements

indicated in the sketch.

–

Insert the yarn stand 1 into the bore of the table top and fasten it

with nuts and washers.

Mount and align yar n stand and thread guiding arm.

The yar n stand and the thread guiding arm must be positioned

vertically on top of each other.

3.3 Self-manufacture of the table top

If you manufacture the table t op yourself, please take the

measurements from the illustrations on page 18.

6 7 m m

5 0 0 m m

1 0 6 0 m m

1 0 0 m m