Operating instructions

2-14

M3M2

F12

F11

F10

F8F7

SETUP

-10

All inputs (F1 ... F12) and outputs (M1 ... M8) are displayed on this page. For

diabled inputs/outputs, the respective icon is crossed out.

At this machine, outputs F1 ... F4, F11 and F12, and inputs M3 ... M8 must

be disabled. Position the cursor on the icon of an input/output and press the

Plus/Minus key to alter the setting.

The outputs are valves and occupied as follows:

Valve description Output connector

F1 Y1 Lift sewing foot pin 1

F2 Y2 Thread cutter pin 3

F3 Y3 Needle cooling pin 5

F4 Thread wiper is not layed upon

F5 Y5 Pinking up/down (pressure 3 bar) pin 9

F6 Y6 Tape cutter pin 11

F7 Y7 Blow out needle threads pin 13

F8 Y8 Waste suction pin 15

F9 Y9 Blow out parts pin 17

F10 Y10 Pinking up/down (pressure 5 bar) pin 19

The inputs are occupied as follows:

Description Input connector

M1 Safety switch for thread cutter monitoring pin 2-4

M2 Switch for tape cutter pin 4-6

3.7 Program inputs and outputs

The inputs and outputs can be enabled/disabled on setup page -10. Enabled

inputs and outputs can be programmed.

To program an input or output, position the cursor on the respective icon and

press the Special key. The setup page will be opened.

Hint

The programming of inputs and outputs is not executed program-specific.

The setting is the same for all programs. Modifications effect all sewing

programs.

3.7.1 Setup page of inputs and outputs