Operating instructions

6.4.5.5 Global Parameters

–

Tap the symbol for “Main Menu”.

The display changes to main menu.

–

Tap the symbol for global parameters.

The display changes to the

global parameters.

–

Select the desired

parameter with the arrow keys.

–

Tap the symbol “E” in order to adopt the selection

–

Changing the value.

–

Tap the symbol “P” in order to save the selection.

Parameter 29: Upper feed maximum track (option

of stepper motor)

Parameter 38: Delayed start of light barrier

Parameter 39: Differential feed (option of stepper motor)

Maximum track

Parameter 40: Base value for upper feed (option of stepper motor)

Parameter 42: Base value for differential lower feed

(option of stepper motor)

Parameter 45: Number of stitches before table blowing

is switched on.

Parameter 46: Duration of the stacker impulse

Parameter 48: Max. speed

Parameter 49: Speed during warp thread separation

Parameter 50: Number of stitches before thread tensioning

is opened (seam end).

Parameter 52: Speed of roll-out device

Parameter 54: Impulse duration of retracted mouse

Parameter 55: Time until after the roll-out device is lifted on the

transport unit.

Parameter 58: Display of the software version

Parameter 59: Number of stitches, for the length of which the

roll-out device

suctions the thread chain (seam start)

Parameter 65: Thread tension lift