Operating instructions

5. Operation of the sewing unit

5.1 Fusing station

5.1.1 Inserting adhesive tape

–

Remove the right supporting disk by pulling the handle 1 strongly.

–

Insert a new roll of adhesive tape 2.

The full roll must rotate counter-clockwise when unwinding.

–

Push the right supporting disk with handle 1 on the shaft again until

it catches.

–

Guide adhesive tape through guide 3.

–

Open flap 4 upwards.

–

Separate adhesive tape 2 from the carrier material 5.

–

Guide adhesive tape 2 under the flap 4 and draw it under the

clamp 7.

–

Guide the carrier material 5 downwards behind the transport

roller 6.

–

Close flap 4.

5.1.2 Switching the fusing station on and off

–

The yellow signal lamp 1 “Power” lights up after the main switch

has been switched on.

–

Press toggle switch 2 in position “ON”.

Note

As long as the signal lamp 3 “Heat” flashes, the lower stamp is being

heated up and has not yet reached the necessary temperature.

7 6 5 4 2

4 3 2 1

3 2 1