Operating instructions

6.4.3 Input - Output test

Via the input - output test the different input and output elements can

be checked.

Input test

–

Press key “P”.

–

Press key “8”.

–

Actuate the corresponding input.

Example:

Cover the light barrier.

–

Press key “Program stop”.

The program is quitted.

Input elements

Switch Designation

01 Light barrier 01

05 Switch “Program stop”

Output test

–

Press key “P”.

–

Press key “8”.

–

Press key “Plus”.

–

Select the output element to be tested with the keys “Plus” or

“Minus”.

–

Switch the output on or off with the key “F2”.

–

Press key “Program stop”.

The program is quitted.

Output elements

Switch Designation

Y01 Sewing foot up / down

Y02 Thread tension lift open / closed

Y03 Contour guide up / down

Y04 Stacker off / on

Y05 Holding stamp up / down

Y06 Auxiliary roller up / down

Y12 Warp separator off / on

Y13 Table blowing off / on

Y14 Dirt suction off / on