Instruction manual

- 43 -
2. To use as a standing work type sewing machine. (Turn the program mode [C] function [PDS] ON.)
The sewing machine can be used as a standing work type sewing machine with the three connections below using the
lever connector. However, take special care to the intrusion of noise, and use the shortest wiring possible.
【Note: Procedure for changing the lever connector】
 Be sure to turn OFF the power switch when connecting or disconnecting the lever connector.
 Do not connect the lever connector when you set the function [PDS] to ON in the program mode [C]
(Direct call number = "530")
［Basic procedure］
(1) Disconnect the lever connector after turning OFF the power switch
(2) Turn ON the power switch and then, set the function [PDS] to ON. The lever connector still disconnects.
(3) Connect the lever connect after turning OFF the power switch.
(4) Turn ON the power switch and confirm the operation.
※ When the error code MA is displayed, press D key and then, it is released.
(1) When operating with an external variable resistor
(Control switch panel [auto] and AT in [P] mode is OFF)
(2) For operating with a high speed
(Control switch panel [auto] and AT in [P] mode is ON)
Lever (white connector)
0V 1
Operation 2
Thread
trimmer
3
Presser foot
lifter
4
Variable speed
command
5
+12V 6
(3) When operation with high speed and inching (Control switch panel [auto] and AT in [P] mode is OFF)
A) When using the lever connector B) When using the lever connector and the option connector
Lever (white connector)
0V 1
Operation 2
Thread
trimmer
3
Presser foot
lifter
4
Variable speed
command
5
+12V 6
D: Equivalent to 1S953 (NEC) (VR30V. IF30mA)
R:1k 1/2W or higher
Lever (white connector)
0V 1
Operation 2
Thread trimmer 3
Presser foot
lifter
4
Variable speed
command
5
+12V 6
Option A (black connector)
0V
1
-
2
-
3
-
4
-
5
Operation
(low speed)
6
Lever (white connector)
0V 1
Operation 2
Thread
trimmer
3
Presser foot
lifter
4
Variable speed
command
5
+12V 6
VC
S1
S2
S3
External variable
resistor 10k
S1
S2
S3
Run
(High speed)
S1
S2
S0
R
D
Run
(
Hi
g
h s
p
eed
)
Run
(Low speed)
S1
S2
S3
Run
(High speed)
S0
Inching