Instruction manual

- 37 -
1. How to use the program mode [I]
To save the setting data ........... Function setting [SAVE*]
(Two types of data, [SAVE1] and [SAVE2] can be saved. The [SAVE1] data can be read out with [LOAD1], and the
[SAVE2] data with [LOAD2].)
(1)
* Enter program mode [I]
([] + [] + [B] + [C] key)
(2)
* Program mode [I] will be entered.
(3)
* When the [D] key is held down, [SAVE1.] will flicker, and
the save process will be executed.
(4)
* Press [D] key over 2 seconds or more, and then the
normal mode will be returned to. (Process is
completed)
Description
A. The currently set data can be saved as simple settings. Saving of the data is completed when the [D] key is held down for two
or more seconds while [SAVE*] is displayed and the display returns to the normal mode.
B. To return to the normal mode from the [SAVE*] display without saving the data, press the [↑] key while holding down the [↓] key.
The set data will not be saved.
C. The saved setting data is saved in the program mode {1} simple setting [LOAD1] or [LOAD2], and can be read out by selecting
[LOAD1] or [LOAD2] with program mode [1].
(As the factory setting, the [412B] data is saved in the simple settings [LOAD1] and the [280M] data is saved in the simple
settings [LOAD2].)
Caution
When this function setting [SAVE*] is used, the settings saved in the program mode [1] simple
setting [LOAD*] before the new data was set will all be cleared. The current setting data will be
newly saved in the simple setting [LOAD*]. Check the current setting data before starting operation.
D. Reading the setting data saved with the [SAVE*] function
The setting data saved with the [SAVE*] function above can be read out with the following procedure (program mode [1]).
(1)
* Enter program mode [1]
([]+[A]+[B] key)
(2)
* Program mode [1] will be entered.
(3)
Press the [] key and set the function to [LOAD1].
(4)
* When the [D] key is held down, [LOAD1] will flicker, and
the loading process will be executed.
(5)
* Press [D] key (2 seconds or more) to return to the
normal mode. (Process is completed)
12 To save the setting data