Instruction manual

- 36 -
14. To adjust the position data for the lever unit ... Function setting [VCSET]
(When error "MA" is displayed)
(1) Set the pedal (lever unit) to the neutral position. (2)
Call out the program mode [Q] function [VCSET].
(This can be called with mode call or direct number call. Refer to
pages 14 to 16. (Direct call number = "1427"))
(3)
[VCSET] will flicker when the [D] key is held down.
(4)
The display will change to [START].
(The neutral position is saved at this point.)
(5) Fully toe down the pedal (lever unit).
(The maximum toe down position is saved.)
Fully heeling the pedal (lever unit).
(The maximum heeling position is saved.)
(6) Return the pedal (lever unit) to the neutral position.
Entering the normal mode
For mode call: [Ļ] + [Ĺ]
For direct number call: Set with
and then press .
Description
The lever's neutral, toe down and heeling positions can be adjusted.
If the [D] key is held down when the pedal is at the neutral position, the display will flicker and change to the [START] display.
(The neutral position is saved at that point.)
After that, repeat the pedal toe down and heeling operation three or more times. (The maximum toe down position and
maximum heeling position are saved at this time.)
When finished, always return the pedal to the neutral state, and then return to the normal mode.
- If the position data for the lever unit is faulty, the error "MA" will appear.
The error “MA” is released by pressing D key.
Confirm the neutral position of the pedal (lever unit), and then save the neutral, toe down and
heeling positions again with the above steps.
- To enter the [VCSET] state with mode call and then return to the normal mode, press down the
[Ļ] and [Ĺ] keys simultaneously. The lever unit's neutral, toe down and heeling positions are not
adjusted in this case.
Repeat three or
more times
Caution
* Enter program mode [Q]
([Ļ] + [A] + [C] keys)