Instruction manual

ManualsBrandsDuerkopp Adler ManualsBusiness equipment1180-5

- 30 -

9. To adjust the tacking accurately

(1) To adjust tacking surely .......... Function setting [D1. CST] + [CT. 10]

(To set the stop time at each tacking corner to 100 msec.)

(1)

Call out the program mode [D] function [D1].

(This can be called with mode call or direct number call. Refer to

pages 14 to 16. (Direct call number = "0600"))

(2)

*Press the [D] key and set to "CST" for the setting

value.

(3)

Call out the program mode [D] function [CT].

For mode call: [Ļ]

For direct number call: Set with , select the number

"0602", and then press .

(4)

*Press the [C], [D] key and set to "10" for the

setting value.

(5)

Entering the normal mode

For mode call: [Ļ] + [Ĺ]

For direct number call: Set with and then press .

Description

A. Set the start/end tacking and No. of switches with Page 17 before making the above setting.

B. When using W tacking, the sewing machine will stop at each corner for 100msec., so the tacking is surely executed.

C. Each time the [D] key is pressed in step (2), the setting will change in the order of [M], [D], [N], [CST], [CSU] and [CSD]. (The

factory setting is [M])

D. The setting range of the stop time is 0 to 990 msec. in 10-msec. intervals. The setting display 10 refers to 100 msec., and 20 to

200 msec. . (The factory setting is 50 msec.)

E. The setting value will change between 0 and 9 each time the [C] and [D] key is pressed in step (4). To lower the value, press the

[C] or [D] key while holding down the [Shift] key.

(2) To align tacking when start/end tacking speed is less than 1000 rpm. .......... Function setting [BM. ON]

(1)

Call out the program mode [D] function [BM].

(This can be called with mode call or direct number call. Refer to pages 14 to 16.

(Direct call number = "0603"))

(2)

*Press the [D] key and set to "ON" for the setting value.

(3)

Entering the normal mode

For mode call: [Ļ] + [Ĺ]

For direct number call: Set with and then press .

Description

A. Set function [BM] to [ON] when start/end tacking speed is less than 1000rpm

B. Set function [BM] to [OF] when start/end tacking speed is 1000rpm or higher. This BM function can be used for a rough tacking

alignment of the start and end tacking.

C. Each time the [D] key is pressed in step (2), the setting will alternate between [OF] and [ON]. (The factory setting is [OF].)

Note) This function can be used for normal tacking (not to stop at each corner).

When the function setting [D1. CST] is set, this function setting [BM. ON] will be invalidated.

Start End

Stop