Instruction manual

- 28 -
6. To continue presser foot lifting after the thread trimming, and to bring down the presser foot after the time
set on the timer has passed .......... Function setting [FUM.ON]+ [FU.C]
(1)
Call out the program mode [P] function [FUM].
(This can be called with mode call or direct number call. Refer to pages 14 to 16.
(Direct call number = "0021"))
(2)
*Press the [D] key and set to "ON" for the setting value.
(3)
Call out the program mode [P] function [FU].
For mode call: [Ļ]
For direct number call: Set with , select the direct call number "0022",
and then press
.
(4)
*Press the [D] key and set to "C" for the setting value.
(5)
Entering the normal mode
For mode call: [Ļ] + [Ĺ]
For direct number call: Set with and then press .
Description
A. Set both [FUM](21) and [FU](22) functions.
B. Each time of the [D] key is pressed in step (2), the set value will alternate between [OF] and [ON]. (The factory setting is [OF])
C. Each time the [D] key is pressed in step (4), the set value will change in order of [M][C][A][T]. (The factory setting is [M])
D. The timer time can be adjusted with the FUM timer setting [FCT](23) in the [C] mode. (The factory setting is 12 sec.)
7. When after trimming thread while sewing thick fabric, needle is stuck and fabric cannot be removed
...................... Function setting [RU.ON]
(1)
Call out the program mode [P] function [RU].
(This can be called with mode call or direct number call. Refer to pages 14 to 16.
(Direct call number = "0036"))
(2)
* Press the [D] key and set the value to "ON".
(3)
Entering the normal mode
For mode call: [Ļ] + [Ĺ]
For direct number call: Set with and then press .
Description
A. After the thread is trimmed, the motor is run in reverse, and the needle is stopped near the needle bar top dead center. The
reverse run angle can be set with [R8] in two-degree increments between 0 and 500. (The factory setting is [30 degrees].) [R8]
can be set by pressing the [p] key after setting the [RU] function in step (2).
B. The setting value will alternate between [OF] and [ON] each time the [D] key is pressed in step (2). (The factory setting is [OF].)