Instruction manual

- 26 -
3. To operate Half-stitch operation with a backstitching switch .......... Function setting [IE.UDS]
(1)
Call out the program mode [C] function [IE].
(This can be called with mode call or direct number call. Refer to pages 14 to 16.
(Direct call number = "0312"))
(2)
*Press the [D] key and set to "UDS" for the setting value.
(3)
Entering the normal mode
For mode call: [Ļ] + [Ĺ]
For direct number call: Set with and then press .
Description
A. Turning ON the backstitching switch connected No.9 pin in sewing machine connector,
backstitching (reverse feed) will start while the sewing machine is running. Half-stitch
operation will start while the sewing machine is stopped.
B. The setting value will be changed with each press of the [D] key in step (2). (The factory
setting is [S7])
Note) When using this function, always return to the normal mode before starting operations.
4. Outputting puller output to spare output 02 ............... Function setting [O2.PUL] + [O2C.ON]
(Example: To set to half-wave 50%duty)
(1)
Call out the program mode [C] function [O2].
(This can be called with mode call or direct number call. Refer to
pages 14 to 16.
(Direct call number = "0421"))
(2)
*Press the [D] key and set to "PUL" for the setting
value.
(3)
Call out the program mode [C] function [O2C].
For mode call: [Ļ]
For direct number call: Set with , select the number
[423], and then press
(4)
*Press the [D] key and set to "ON" for the setting
value.
(5)
Entering the normal mode
For mode call: [Ļ] + [Ĺ]
For direct number call: Set with and then press .
Description
A. Select puller output [PUL]. Set to connect [O2] and [PUL].
B. The spare output O2 turns ON only when the presser foot lifter is operating.
sewing machine connector