Instruction manual

ManualsBrandsDuerkopp Adler ManualsBusiness equipment1180-5

- 12 -

1. To change solenoid voltage DC24V/DC30V

To change solenoid voltage from 24V to 30V

(1) Remove the front cover from the control box.

(2) Reconnect the connector inserted in JP1 on the PCB to the

30V side.

(3) Set the cover to the original position after change.

To change solenoid voltage from 30V to 24V

(1) Remove the front cover from the control box.

(2) Reconnect the connector inserted in JP1 on the PCB to the

24V side.

(3) Set the cover to the original position after change.

2. Changing the output voltage between 0VDC and 5VDC

(1) Remove the control box cover.

(2) Change the output voltage 5/12VDC with the jumper JP3

and JP4 on the front cover PCB as shown on the right.

Change the output voltage 0/5VDC with the jumper JP5 on

the front cover PCB.

(3) The output voltage can be changed by reconnecting the

connector as shown on the right.

(4) The factory setting

Connector

factory

setting

Connector (Pin No.)

JP3 +12V No.3 pin of the option A

JP4 +5V No.7 pin of the option B

JP5 0V No.10 pin of the sewing machine

(5) After change, always set the cover to the control box.

9 Changing the solenoid voltage and output voltage

Wait at least 10 minutes after

turning the power switch OFF

before o

enin

the control box.

Do not change the JP1,JP2 and

JP6 from the factory setting.

Control box cover side

24V setting (factory setting)

30V setting

Control box side