Instruction manual

ManualsBrandsDublo ManualsComputer equipmentDFC-10

Table Of Contents

COVER
1. INTRODUCTION
2. TABLE OF CONTENTS
3. SAFETY PRECAUTIONS
4. USAGE PRECAUTIONS
5. FEATURES OF THIS MACHINE
6. NAMES OF PARTS
7. NAMES AND FUNCTIONS OF CONTROL PANEL PARTS
8. PRECAUTIONS ON LOADING PAPER
9. OPERATIONS
10. LOADING PAPER ACCORDING TO COLLATION MODE
- 10-1. Loading paper for normal mode
- 10-2. Loading paper for interleaving mode
- 10-3. Loading paper for alternative mode
- 10-4. Loading paper for block mode
- 10-5. How to load paper when downstream unit is connected
- 10-6. Loading paper according to paper size
11. USING THE CONTROL PANEL
- 11-1. LCD window
- 11-2. Setting the collation mode
- 11-3. Setting the number of interleaves
- 11-4. Setting the count display method
- 11-5. Setting the paper receiving method
- 11-6. Other settings
12. CONNECTING THE DOWNSTREAM UNIT
- 12-1. Connecting the DBM-120 and DBM-120T
- 12-2. Connecting DC-S and DC-S4
13.DOUBLE-FEED DETECTION FUNCTION
14. WHEN BIN ERROR LAMPS LIGHT_BLINK
- 14-1. When an error lamp lights in green
- 14-2. When an error lamp lights in red
- 14-3. When an error lamp blinks in green
- 14-4. When an error lamp blinks in red
15. WHEN ERROR MESSAGES ARE DISPLAYED
- 15-1. When _No Paper_ is displayed
- 15-2. When _Tray Full_ is displayed
- 15-3. When _Feed error_ is displayed
- 15-4. When _Preset Error_ is displayed
- 15-5. When _Mis-Feed_ is displayed
- 15-6. When _Double Detect_ is displayed
- 15-7. When _Paper Jam_ is displayed
- 15-8. When _Stacker jam_ is displayed
- 15-9. When _Feed Cov. Open_ is displayed
- 15-10. When _Int. Setup Error_ is displayed
- 15-11. When _On-line err_ is displayed
16. TROUBLESHOOTING
17. TROUBLESHOOTING GUIDE
18. LCD MENU
19. CLEANING THE UNIT AND REPLACING EXPENDABLE PARTS
20. SPECIFICATIONS

11. USING THE CONTROL PANEL

11-6. Other settings

If the paper ejected to the downstream unit or paper receiving table is not aligned prop-

erly, or the same collation operation is repeated, perform the "Overlap", "Speed", and

"Processed set repeat" settings at the "Other Settings" screen on the control panel.

Setting overlap

If paper ejected to the downstream unit is not

aligned properly, this can be improved by shifting

overlap of collated paper during ejection.

At shipment, “Overlap ” is set to “None”.

Note Set to “None” when ejecting to the pa

per receiving table.

Press the key to display

"Other settings".

Press the key and display the

screen for selecting “Overlap",

"Speed", and Initial Qty Rpt".

Press the key to display the "

Overlap" screen, and next press

the

key to display the screen for se-

lecting the overlap .

Press the key to display the

screen where the overlap to be set

is blinking.

Press the key and save the Over-

lap selected at step 3.

Press the key to return to the

standby screen.

Press the key until the standby screen

is displayed.

To redo the setting, press the key an-

other time to return to step 3.

Adjust the overlap while checking the paper

alignment state.

5mm (0.2")

10mm (0.39")

Overlap : Large

Overlap : Small