Instruction manual

17
10. LOADING PAPER ACCORDING TO COLLATION MODE
10-5. How to load paper when downstream unit is connected
• Paper ejected from the DFC-12/10 is punched, stapled, folded, and trimmed as shown
below by a downstream units.
• The interleaving mode cannot be set if a downstream unit is connected.
10-4. Loading paper for block mode
Page 1-a
Page 2-a
Page 3-a
Page 4-a
Page 5-a
Page 6-a
Page 1-b
Page 2-b
Page 3-b
Page 4-b
Page 5-b
Page 6-b
Group of block 1/2
Group of block 2/2
Group of block 1/2
Group of block 2/2
DC-SP
DBM-120 + DBM-120T
DC-S4
DC-S
DC-S4 (When attaching the option)
DC-S
Página 1
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
Page 12
Page 1
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
Page 12
Page 1
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
Page 12
Page 1
Page 12
Page 1
Page 12
Punched holes
Corner stapling
Corner stapling
Side stapling
Side stapling
Side stapling
Side stapling
Saddle stapling
Saddle stapling
DC-S4 (When attaching the option)
Page 1
Page 12
DBM-120
The bins can be divided into two blocks
(6 bins each) to collate paper in blocks.
For the DFC-10, bins are divided likewise
5 bins each.
Paper feed starts from bins 1 to 6 (block 1/
2). When paper on any bin of the block runs
outs, operation is stopped. Press the Start
key to switch paper feed to bins 7 to 12 (block
2/2).
• For details on the loading direction of paper
and paper ejection direction, refer to "10-1.
Loading paper for normal mode" ( page
15).