SG3/SG4/SG5 INSTALLATION/OWNER'S MANUAL Universal Marine Splash Guard Dual
m SG3/SG4/SG5 INSTALLATION Preparation Protect your marine head unit from damage and the harsh marine environment with the SG3/SG4/SG5 splash guard. This marine grade cover fits most single DIN size head units and will protect against splashes and debris. Before You Start • Disconnect negative battery terminal. Consult a qualified marine technician or service manual for instructions. • Due to differences in head units.
SG3/SG4/SG5 INSTALLATION • Mounting Mounting • Open splashguard and detach side covers by pulling outward from the inside of side cover. • Insert supplied mounting bolts through washers and into mounting holes as shown below. • Place gasket between back side of splash guard and mounting surface and secure the splash guard in place with supplied nuts. • Install head unit into splash guard opening. This may vary depending on head unit manufacturer and installation instructions.
• SG3/SIWSG5 WARRANTY Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. Dual Electronics Corp. agrees, at our option. during the warranty period. to repair any defect in material or workmanship or to furnish an equal new.
DMP672/DMP672B INSTALLATION/OWNER'S MANUAL 6.
• DMP672/DMP672B INSTALLATION Preparation/Installation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Use extreme caution when drilling holes to avoid damaging fuel lines. hydraulic lines or existing wiring. • If additional wiring is required. we recommend that you run all wires prior to mounting your speaker in place.
DMP672/DMP6728 WARRANTY • Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. What to do? 1. Before you call for service. check the troubleshooting guide in your owner's manual.
. . DMP672/DMP672B SPECIFICATIONS Specifications Outside Diameter 7.13" Mounting Depth 2.13" Mounting Height .87" Cut-out Diameter 5.13" Frequency Response 45Hz-15kHz Sensitivity 88dB 1W/1M Impedance 4ohms RMS Power 20 Watts @ 1kHz Peak Power 100 Watts @ 1kHz Design and specifications subject to change without notice. Dual Dual Electronics Corp. Toll Free: 1-866- 382-5476 9AM-5PM EST, Monday-Friday www.dualav.com © 2019 Dual Electronics Corp. All rights reserved.
Quick Start Guide Digital Media Receiver • • • •••••••••••• • To download the complete. model-specific manual. please visit www.dualav.com/support/manuals.php or call 1-866-382-5476. 9AM-5PM EST (Monday-Friday).
Installation Before You Start • Consult a qualified technician for instructions. Dual always recommends professional installation. • Disconnect negative battery terminal. • Remove trim ring from unit (if installed). • Remove 2 transit screws located on top of the unit (if applicable). • Insert the removal keys, and remove the mounting sleeve from the head unit. Note: Most vehicles require an installation kit.
Mounting the Head Unit: Typical DIN mounting Dashboard or Installation Kit Step 1: Insert the mounting sleeve into the installation kit or dashboard. Dashboard or Installation Kit Step 2: Bend multiple mounting tabs around the mounting sleeve until the mounting sleeve is secure. ~ ~~...,,......_,.. Dashboard or lnstallatlon Kit MountingSleeve - Step 3: Connect all wiring harnesses and slide the head unit into the mounting sleeve until it clicks into place.
General Operation Power On/Off Changing Modes Volume Mute Auxiliary Inputs Reset Setting the Clock Display Audio/ Menu Press the ~ button to turn the unit on. Press ~ again to turn unit off. Press MODE to select between Radio. USB. Bluetooth. AUX. Modes of operation are shown in the display. Adjust volume using volume knob. Press ~ to silence the audio. Press ~ again to resume listening at the previously selected volume. Insert a 3.5mm cable in the units front AUX port.
AM/FM Tuner Operation Seek Tuning Manual Tuning Band Press TUNE ◄◄ or TUNE ►► to seek to previous or next strong station. Press and hold the TUNE ◄◄ or TUNE ►► to enter manual tuning mode. Then press TUNE ◄◄ or TUNE ►► momentarily to move radio frequency down or up one step at a time. Press and hold TUNE ◄◄ or TUNE ►► to advance quickly. Press BAND to select between FMl. FM2. FM3. AMl and AM2 bands.
USB Operation Playing MP3 Files To play MP3 files, insert a USB device containing MP3 files. Track Select Press TUNE ►► to skip to the beginning of the next song. Press TUNE ◄◄ to skip to the beginning of the previous song. Fast Forward and Reverse Pause Folder Access Repeat Press and hold TUNE ►► . or TUNE ◄◄ to fast forward or reverse a track. Press ►/ II to temporarily stop playback. Press ►/ II again to resume playback. Folder can be found by pressing Folder Up or Folder Down.
Bluetooth® Operation* Preparation Before using a Bluetooth device. it must be paired and connected. Ensure that Bluetooth is activated on your device before beginning the pairing process. Pairing a New Device The head unit broadcasts the pairing signal constantly when no devices are connected. Complete the pairing sequence from your Bluetooth device. Refer to the owner's manual for your device for more details.
Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. (Note that select marine products carry a 2-year warranty. Please visit www.dualav.com for details.) Dual Electronics Corp. agrees, at our option, during the warranty period.
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received. including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
