LUR66E INSTALLATION/OWNER'S MANUAL 2-Way Outdoor Rock Speaker
LUR66E INTRODUCTION Welcome Congratulations on your purchase of the LUR66E rock speaker. A high level of design experience and engineering went into its creation. With the rugged look of weathered sandstone, the LUR66E 2-way rock speaker is extremely versatile and are perfect when placed in areas ranging from indoor use like terrariums and interior gardens to back yards, patios and pool or spa settings.
LUR66E INSTALLATION Sound Coverage and Speaker Placement The LUR66E is sold separately, as many outdoor installations have multiple zones. It is assumed for the purpose of this manual that the rock speaker will be installed using a minimum of two speakers. When deciding on the placement, allow for a total coverage area of approximately 100 to 450 sq.ft. per pair of rock speakers. This estimate is based on the ambient noise levels of a typical outside patio or yard and your personal listening level.
LUR66E CONNECTION Connections The LUR66E rock speaker has a two-conductor speaker wire surrounded by a cable sleeve exiting the bottom of the speaker. Any speaker cable used to extend the connection should be of a similar size (wire gauge) running from the speaker location to your audio system. You may wish to purchase certified direct burial cables (environmentally rated speaker wire) and/or a watertight burial box which also works well for the purpose of protecting your connection.
LUR66E TROUBLESHOOTING Distortion Using Loudness If you hear obvious distortion from the speakers, immediately lower the volume level of your receiver. Distortion often indicates the speaker is being over driven, and damage can result by playing at high volume levels for prolonged periods of time. The Loudness function on most receivers is designed to enhance the bass and treble (for background music or listening at low volume levels).
LUR66E WARRANTY Limited Two Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of two years from the date of the original purchase. Dual Electronics Corp.
LUR66E SPECIFICATIONS Specifications Frequency Response Nominal Impedance Sensitivity 70Hz-20kHz 8 ohms 88dB (2.83 Volts RMS measured @ 1 Meter) RMS Power 60 Watts @ 1kHz Peak Power 150 Watts @ 1kHz Dimensions 9.63” x 8.75” x 8.75” Design and specifications subject to change without notice.
Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2009 Dual Electronics Corp. All rights reserved.
