Owners manual

Page 2 - Continued . . .

Option II - Drop Down Plates - Use to adjust lower

Attach Drop-Down Plate (H) to Right (F) / Left (E) and Center

Support (AB) Brackets with two Carriage Bolts - 5/16” x 3/4”

(AA), two Flat Washers 5/16” (V) and two Lock Nuts 5/16” (W).

NOTE: Offset Plates (I) may be needed to not interfere with the

topper mounting areas.

Option III - Offset Plates - Use to avoid an obstruction

In the case of some truck beds, or due to an obstruction, the

standard clamp spacing will not work. In such cases, use one or

both Offset Plates (I) to move the Clamp Assembly to a suitable

location. Attach Offset Plate (I) to Right (F) and/or Left (E)

Bracket with two Carriage Bolts - 5/16” x 3/4” (AA), two Flat

Washers 5/16” (V) and two Lock Nuts 5/16” (W).

Note: Offset Plates should extend toward the middle of the

Humpstor. Offset Plates are not needed on the Center Support

Bracket (AB).

Option IV - Drop Down and Offset Plates

In some cases both Offset Plates (I) and Drop-Down Plates (H) are

required. Connect Offset Plate holes to Left or Right Bracket slots

and connect Drop-Down Plate holes to Offset Plate slot.

E (opposite)

F (shown)

E (opposite)

F (shown)

E (opposite)

F (shown)

Option I - Topper

Use this option for most standard installations for truck beds with

toppers. No additional Drop Down Plates (H) or Off-set Plates

(I) are needed. Use the standard Right (F) / Left (E) and Center

Support (AB) Brackets.

STEP 3 - Assemble Brackets

E (opposite)

F (shown)

AB (center support)