User`s manual

15
DELTA 12
Up-DownENTER
ENTER
MENU
Up-Down
ENTER
SLAVE MODE
Slave mode for ChPr program.
All slave units will be
synchronised with master unit,
running their own Chpr program.
Up-DownENTER
MENU
Up-Down
WIRELESS DMX
Wieless DMX enabled / disabled.
By activating WDMX MODE, it will
be possible to control DELTA 12 via
D.T.S. ANTENNA Wireless DMX
Transmitter (cod. 03.E1271).
WIRELESS DMX system on
DELTA 12 is available on
request.
NOTE:
needed (cod. 03.LA.012).
External IP65 2dbi
omnidirectional Antenna
needed (cod. 0508A040)
Wireless DMX receiver card
Up-DownENTER
ENTER
ENTER
Logging on DELTA 12 (WIRELESS DMX must be enabled on DELTA 12 unit)
To log on the Delta 12 in the WIRELESS system simply press and quickly release the function button on the transmitter .
The transmitter will start flashing rapidly red/green scanning for new free receivers / DELTA 12 units. When a DELTA 12 logs on to
the transmitter the LINK green light on transmitter starts to flash rapidly.
After approximately 10 seconds the transmitter will jump back to normal mode and continue transmitting data. The DELTA 12 now
try to synchronize to the transmitter.
When synchronized to the transmitter, 2 different modes are possible:
1. Antenna transmitter has detected and transmits a DMX signal, in this mode a solid green light is seen on the transmitter and
solid display is seen on DELTA 12.
2. No DMX signal connected, the Antenna transmitter will flash red/green; display blinking on DELTA 12.
To log DELTA 12 off from a transmitter simply select UNLINK function under WIRELESS DMX MENU
and press ENTER.
When DELTA 12 is logged off the display is blinking, meaning its available for log in on a new transmitter.
Logging out a DELTA 12.
Select UNLINK function under WIRELESS DMX MENU and press ENTER.
When DELTA 12 is logged off the display is blinking, meaning its available for log in on a new transmitter.
Logging out all DELTA 12 linked to a transmitter.
Press and hold the function button of the transmitter for about 3 seconds.
When the display is blinking on DELTA 12, it mean that the units are logged out.
Transmitter, LEDs Status:
Flashing red/green, no dmx connected.
Solid green, dmx signal detected and transmitted.
Fast flashing red/green, log in mode (every free DELTA 12 unit, not logged in to any other transmitter, will be logged on)
DELTA 12, Status:
Display blinking, not logged on to a transmitter (free).
Solid display, logged on to a transmitter and receiving dmx data.
UNLINK = LOG OUT
WIRELESS DMX SYSTEM
ENABLED
WIRELESS DMX SYSTEM
DISABLED
ENTER
Up-DownENTER
ENTER