Datasheet

14- AUTOMATIC OPERATION (AUTO)
DELTA 8 B
20
DELTA 8 B can work in automatic mode without a DMX controller. First of all connect the projectors with a
DMX cable (picture below). A maximum quantity of 32 slave units can be connected to the same Master unit.
To activate Auto mode on the first unit, use the menu to run through the different modes until AUTO appears
on the display, and press enter.
Now it is possible to choose between the different pre-programmed games (cUPr-rAIn-cU01/cU16-
WH01/WH16) or cHPr which is user programmable through REC mode. To confirm game activation press
ENTER on the selected GAME.
cUPr-rAIn-cU01/cU16-WH01/WH16
The first unit that will work as a Master should be placed in Automatic mode (AUTO), the other units have to
be placed in 9 channels DMX mode (MODE 9CH) and the DMX address should be set at A001.
For rAIn (rainbow) game it is possible to select the speed for the colour changhing (SPEE).
DIMMER function (in AUTOMATIC MODE) is active for all the programs.
SHUTTER function (in AUTOMATIC MODE) is active only for cU01/cU16 and WH01/Wh16 macros.
cHPr MASTER/SLAVE
The first unit that will function as a Master must be set to Automatic mode (AUTO), the other units must be
set to Slave mode (SLAV), selectable through the menu. In this way all the Slave units will be synchronised
with the master and running their own cHPr game.
On the master unit it is possible to vary the Speed time (SPEE) for the colour changhing and the Wait time
(UAIt) between the steps.
Speed time and Wait time on the Master, have priority on the slave units.
NB: It is possible to run cHPr on the Slave units even though these do not have cHPr programmed. You can
do this by setting the units to 9 ch DMX MODE and selecting DMX address A001.
MASTER SLAVE 1 SLAVE 2 SLAVE 3 SLAVE 32