Datasheet
Table Of Contents
- Pagina 1
- Pagina 2
- Pagina 3
- Pagina 4
- Pagina 5
- Pagina 6
- Pagina 7
- Pagina 8
- Pagina 9
- Pagina 10
- Pagina 11
- Pagina 12
- Pagina 13
- Pagina 14
- Pagina 15
- Pagina 16
- Pagina 17
- Pagina 18
- Pagina 19
- Pagina 20
- Pagina 21
- Pagina 22
- Pagina 23
- Pagina 24
- Pagina 25
- Pagina 26
- Pagina 27
- Pagina 28
- Pagina 29
- Pagina 30
- Pagina 31
- Pagina 32
- Pagina 33
- Pagina 34
- Pagina 35
- Pagina 36

11.1-DMX Addresses
can be used in seven different modes: 9 DMX channels mode (default), 5 DMX
channels mode (Shutter + Dimmer + RGB), WALL mode (6 DMX channels; for use with DTS Wall mounted
DMX controller 0514L007), M3CH mode (4 DMX channels; Dimmer + RGB), RGB mode (3 channels), 1
DMX channel mode or CUSTOM DMX mode (not yet implemented).
If you want to use the DELTA 8 B in 9 channels mode, select the 9 CH mode from the MODE menu and
set the following addresses on the mixer:
11.2-Selecting the DMX address
1) Press the UP-DOWN key until you reach the required DMX channel. The numbers on the display will
start to flash (but the new DMX address hasn't yet been set).
2) Press ENTER to confirm your selection. The numbers on the display will stop flashing and the
projector is now setted to the new DMX address.
TRICKS:
if you keep pushed the UP or DOWN keys, the channels are calculated more quickly and you get a
faster selection.
DELTA 8 B (all models)
Projector 1 A001
Projector 2 A010 If you want to select the next projector, just add “9”
Projector 3 A019
….. A….
projector 6 A046
Please refer to an authorised D.T.S. service centre.
D.T.S. Firmware upgrade utility program.
D.T.S. Firmware upgrade utility
12 FIRMWARE UPDATING
Warning:
This procedure require a base knolewge of Windows based computer applications
.
To update the software version of the DELTA 8 B you will need:
D.T.S. RED BOX interface (D.T.S. Code: 03.LA.008).
USB-DMX Driver for the D.T.S. RED BOX interface .
(The driver and the installation procedure are available in our web site www.dts-lighting.it)
Updating the software version.
Please follow the procedure below to perform the update:
1. Install the D.T.S. RED BOX USB-DMX driver on the PC you will use to update the unit software.
2. Connect the D.T.S. RED BOX interface to the PC by using a USB cable.
3. Connect the D.T.S. RED BOX interface to the fixture by using a DMX cable.
4. Download the new software version into the unit by using program.
It will be possible to download the software from the reserved area of D.T.S. web site:
www.dts-lighting.it.
!
DELTA 8 B
12