Datasheet

11.1-DMX Addresses

11.2-Selecting the DMX address

1) Press the UP-DOWN key until you reach the required DMX channel. The numbers on the display will

start to flash (but the new DMX address hasn't yet been set).

2) Press ENTER to confirm your selection. The numbers on the display will stop flashing and the

projector is now setted to the new DMX address.

TRICKS:

if you keep pushed the UP or DOWN keys, the channels are calculated more quickly and you get a

faster selection.

DELTA 8 R (all models) have 15 DMX control channels.

Here below are described the DMX channels addressing for the controller:

Projector 1 A001

Projector 2 A016 If you want to select the next projector, just add “15”

Projector 3 A031

….. A….

projector 6 A091

Please refer to an authorised D.T.S. service centre.

D.T.S. Firmware upgrade utility program.

D.T.S. Firmware upgrade utility

12 FIRMWARE UPDATING

Warning:

This procedure require a base knolewge of Windows based computer applications

To update the software version of the DELTA 8 R you will need:

D.T.S. RED BOX interface (D.T.S. Code: 03.LA.008).

USB-DMX Driver for the D.T.S. RED BOX interface .

(The driver and the installation procedure are available in our web site www.dts-lighting.it)

Updating the software version.

Please follow the procedure below to perform the update:

1. Install the D.T.S. RED BOX USB-DMX driver on the PC you will use to update the unit software.

2. Connect the D.T.S. RED BOX interface to the PC by using a USB cable.

3. Connect the D.T.S. RED BOX interface to the fixture by using a DMX cable.

4. Download the new software version into the unit by using program.

It will be possible to download the software from the reserved area of D.T.S. web site:

www.dts-lighting.it.

DELTA 8 R