Owner`s manual

PureLink by Dtrovision

Installation and Connection Instructions

1. Turn off both the video source and the display before connecting any cables.

2. Connect DVI cable between the source and OBC II transmitter AND between the

OBC II receiver and the display.

3. Connect LC terminated fiber optic cables according to the picture below;

4. Connect the power supply unit to both OBC II transmitter and receiver units.

5. Turn on Display

6. Turn on Video Source

EDID Management

For reliability and correct signal transmission of the video source, EDID emulation is recommended. Please

follow the steps below;

1. Connect the HDX II transmitter’s HDMI input port to the Display’s HDMI input port

2. Press and hold EDID switch for about 2 seconds until the Display’s EDID is successfully saved on t

o the transmitter. ‘EDID PASS’ message on the LCD panel indicates successful EDID save. ‘EDID ER

ROR’ message indicates failed EDID save. Please repeat the step #1 and #2.

** Factory Default EDID is based on 1080p.